The 50-100mil Adapter allows you to connect a mikroProg for STM32 programmer and hardware debugger to a Cortex debug connector.

The EasyConnect Board is an accessory board that provides easy access to the MCU pins via screw terminals. This additional board features onboard screw-terminated connectors that can handle solid and stranded wires. These connectors enable eight wires to be easily ...

The Trycom LI-RS232-9M9F 1.8m RS-232C cable.

The LED Driver Click Board™ is based on the MCP1662 high-voltage step-up voltage driver from Microchip. The Click Board™ is designed to run on either 3.3V or 5V power supply. It communicates with the target microcontroller over PWM pin on ...

The Raspberry Pi 3 Click Board™ Shield lets you add two mikroBUS sockets to your Raspberry Pi 3. The shield allows you to experiment with hundreds of Click Boards™ from our ever-expanding range. WiFi, Lora, Bluetooth, GSM, GPS, RFID, OLED, ...

The LED Driver 3 Click Board™ is an RGB LED driver, capable of driving RGB LEDs with up to 30mA per segment, via the digital I2C interface. It comes with an RGB LED on-board, and is capable of displaying a ...

The M-Bus Master Click Board™ is a complete solution for a master node in M-Bus networks. The M-Bus ("Meter-Bus") is a new European standard for remote reading of meters and it is also usable for all other types of consumption ...

Protocol Analyser Trigger Module is an optional software module which can be purchased.

The Trycom T-SNAP DIN-rail Mounting Bracket has been designed to mount Trycom interface modules to a standard DIN rail. It can also mount any type of enclosure to a DIN rail.

TC2030‐MCP to SPY‐BI‐WIRE adapter board which allows use of our Tag‐Connect TC2030‐MCP series Plug‐of‐Nails™ cables with later versions of TI’s MSP430 MCU that support the SPY‐BI‐WIRE (2‐Wire) JTAG interface.

The Tag Connect TC2050-CLIP is intended to hold a TC2050-xxx-NL cable on a PCB temporarily. Supplied as a single clip.

TC2050 10 Pin Plug-of-Nails™ to 0.050″ pitch 10 pin ribbon connector suitable for ULINK2 and similar debuggers that use the Samtec FTSH-105-01 style micro-header.

Experience the power of the Total Phase Beagle USB 12 Analyser, a cutting-edge tool that provides unparalleled insights into USB data transmission. This innovative analyser is your gateway to understanding the intricate workings of USB technology at a level of ...

Introducing the Level Shifter Board: Elevate Your Voltage, Amplify Your Performance! Are you ready to supercharge your Total Phase experience? Look no further than our cutting-edge solution: The Level Shifter Board. Designed with precision and innovation in mind, this remarkable ...

The Trycom TRP-C06 allows an RS-232C line signal to be optically isolated and bi-directionally converted to RS-422 or RS-485 standard and communicate data along twisted pair lines up to 1.2Km in length. This makes it ideal for connecting your PC ...

The LED Driver 10 Click Board™ is a compact add-on board that simplifies the control of multiple LEDs. This board features the TLC59283, a 16-channel, constant-current sink light-emitting diode (LED) driver with pre-charge FET from Texas Instruments. Each LED channel ...

The Accel 18 Click Board™ is a compact add-on board that contains an acceleration sensor. This board features the MC3419, a digital output 3-axis accelerometer with a feature set optimized for consumer product motion sensing from MEMSIC. It allows selectable ...