The B&W Type 05 Black outdoor case is made from Ultra-High-Impact ABS plastic. It is very sturdy and has been designed to be used in operating temperatures from -40°C to 80°deg C.

The BIGAVR6 Development Board supports 64- and 100-pin AVR microcontrollers. It comes with the ATMEGA128 microcontroller. The system features a USB 2.0 programmer and many peripheral modules such as a touch panel controller, CAN, RTC etc. In-Circuit Debugger On-board USB ...

Adaptor Instructions 1. Make sure the triangle mark on the bottom left PCB board aims at the triangle mark on the DediProg devices. Caution: Incorrectly installed the socket adaptor may cause device and socket damage. 2. Align the Pin 1 ...

WORLD'S FIRST DEBUGGER OVER WIFI On-board Debugging and programming over WiFi Fusion for PIC32 development board integrates first-ever embedded debugger/programmer over WiFi. Enjoy cable-free world! *CODEGRIP Wifi License is available as an add-on feature. Access anywhere, under any circumstances at ...

Specifications Model Hantek-2D72 Hantek-2D42 Hantek-2C72 Hantek-2C42 Oscilloscope Bandwidth 70MHz 40MHz 70MHz 40MHz Channel 2CH+DMM+AWG 2CH+DMM+AWG 2CH+DMM 2CH+DMM Horizontal Sample Rate Range 250MSa/s(Single-channel), 125MSa/s(Dual-channel) Waveform Interpolation (sin x)/x Record Length Max. 6K for single-channel; 3K samples per dual-channel SEC/DIV Range 5ns/div~500s/div ...

The Fan 2 Click Board™ carries the MAX31760 precision fan-speed controller. It can measure temperature and adjust the fan speed to keep the temperature at the same level. Fan 2 click can also control two fans at the same time. ...

The OBD-II to DB9 Cable enables you to connect with your car's OBD-II system. You just need to plug OBD II connector on one end to your car and the other end it into some sort of hardware interface which ...

6-Pin Legged TC2030 Plug-of-Nails programming cable for use with ARM Cortex processors.This special cable has a 6-pin TC2030 Tag-Connector and a 10-pin ribbon and ribbon connector. It mates with the FTSH-105 style micro-headers used for Cortex Debug Connector; as found ...

14-pin Plug-of-Nails programming cable – With Legs VersionFitted with 14-pin (2×7) 0.05″ ribbon cable connector.For TC2070 footprint specifications, please download the similar TC2070-IDC Datasheet below (pdf)See also TC2070-IDC-NL-050 (no-legs) version.

This product is intended to temporarily hold a TC2030 -NL ("No Legs") cable in place on a PCB. This solution will help when board space is at a premium and you need a hands free solution for debugging. Supplied as ...

The RK-System Uprog-ICP is a small, hand-held programmer, designed for programming EEPROM, Flash EPROM, microcontrollers (8051, ARM, PIC, AVR etc.) and logic devices (CPLD, FPGA) in the target board. A range of hardware interfaces are also supported including I2C, SPI, ...

Product Information The J2101A Injection Transformer is presently the prevalent method for connecting the network analyzer to the circuit being tested, and is primarily used for control loop stability measurements. The goal of the transformer is to inject a signal ...

Acute TravelData TD3116E / TD3216E Pocket Data Generators 1) Product Introduction The Acute TravelData TD3116E and TD3216E are compact, PC-controlled digital pattern generators. In plain terms, they create clean, repeatable digital signals so you can stimulate, debug, and automate your ...