The 10-Pin Split Cable has a 10-pin header that can be directly connected to the Serial Flash Emulator (EM100 or EM100Pro) and SF600 programmer. Each split cable has a different colour and is labelled with the pin name to make ...

The SF600 ISP cable is used to connect the ISP SF600 programmer to the 2X6 2.54mm ISP Pin Header on board offering the possibility to update directly the SPI Flash content. In case of frequent connections, the ISP cable must ...

The Intel ISP Adaptor C2 is for connecting EM100Pro, EM100Pro-G2, SF600, and SF600Plus to Intel motherboard.Mated with Intel 2x10 connector (Samtec: ASP-159358-02 or TFM-110-02-S-D-A).The cable length is around 8 cm; a header is added at the end.Supports Quad IO.

The RN4871 Click Board™ carries the RN4871 Bluetooth® 4.2 low energy module from Microchip. The Click Board™ is designed to run on a 3.3V power supply. It uses ASCII Command Interface over UART for communication with target microcontroller, with additional ...

The AudioAmp 4 Click Board™ is a low-power audio amplifier with a digital volume control. It is equipped with the LM4860, an audio amplifier IC capable of delivering up to 1W of continuous power to an 8Ω load. It has ...

The RF Meter 3 Click Board™ is a compact add-on board that collects information, analyzes RF power, and displays information in an easy-to-read digital format. This board features the LT5581, a low-power monolithic precision RMS power detector from Analog Devices. ...

The GPS&GLONASS External Passive Antenna is a 100% waterproof external antenna, which represents an excellent choice for all GPS/GNSS Click boards™ from our offer. It has wide bandwidth that supports GSM/GPRS modules. The antenna has 3m cable with SMA male ...

The SF600-ISO-Board-2 is isolation board is used to reduce the cable interference to the motherboard boot performance when SF600/SF600Plus is attaching to the motherboard. User can add this isolation board in between the cable and the SF600/SF600Plus if the SF600/SF600Plus ...

The NFC Tag 5 Click Board™ is a compact add-on board that contains a compact NFC tag IC. This board features the M24LR64E-R, a dynamic NFC/RFID tag IC with a dual interface 64-Kbit EEPROM from STMicroelectronics. It features an I2C ...

The Expand 14 Click Board™ is a compact add-on board that contains a multi-port I/O expander. This board features the CAT9555, a CMOS device that provides 16-bit parallel input/output port expansion from ON Semiconductor. The CAT9555 contains two 8-bit configuration ...

The Clock Gen 6 Click Board™ is a compact add-on board representing a digital oscillator solution. This board features the MIC1557, an IttyBitty CMOS RC oscillator designed to provide rail-to-rail pulses for precise time delay or frequency generation from Microchip ...